Wurth Power Panel Bonder Adhesive 2-Part

Power Bond Description Powerbond Motor Vehicle Body Adhesive - 225 Technical Data Chemical Basis: Epoxy Resin Color: Black Density: 1.1 g/cm3 Application temperature: +59?F to +77?F Application time: 60 minutes* Hardening Time: 4 hours* Final strength: After 72 hours* Shore D hardness (DIN 53505): 80 Tensile strength (ASTM D-638): 30 MPa* Tensile shear strength (EN 1465): 1.7 MPa (after 4 hours)*, 13.3 MPa (after 8 hours)*, 19.0 MPa (after 17 hours)* Resistant to: Fuels (petrol, diesel oil), motor and transmission oil, coolant Thermal stability: -22?F to +248?F (for short peaks up to +374?F) Shelf Life: 12 months *measured at 73.4?F High-strength two-component epoxy resin system for repairs to motor vehicle bodies. Features High-strength epoxy resin adhesive - The repair restores the original strength and stiffness. - Fewer spot welds - Meets the requirements of motor-vehicle manufacturers Glass-particle technology - Even if strong pressure is exerted, an adhesive thickness of 0.7 to1.2 mm remains Excellent stability - The adhesive will not run on vertical surfaces (thixotropic) Excellent corrosion protection - The original rust resistance is maintained - Corrosion is prevented at welds Can be through-welded Can be ground and painted over Free of silicone and VOC Applications Structural adhesive for steel, aluminum and fiber-reinforced plas-tics (FRP, CFRP). For gluing motor vehicle body parts such as side-walls, wheel arches, roof and door plates. Note Not suited for load-bearing vehicle body parts (e.g. A-pillar, frame side bar). If body parts are only partially replaced, do not glue on ­visible surfaces since ­shadow seams may appear. Observe the vehicle manufacturer’s ­repair instructions.